Final Year Project

My Final Year project is about Disabled people car parking system using RFID sensor.
Im a networking student bachelor in data communication and networking but my final year project is more on electronics. So even it is more to electronic component , i can do this project and my supervisor accept this project because it related to the network. What im saying is , this project is focus on the RFID which is radio frequency identification that can detect the RFID tags or card that will be used by disabled people when entering into the parking slot. There are also PIC microcontroller that will be use for program the programming language that act as a program that will control the system. Programming language C will be use to program this PIC and MPLAB software as a software that will write the program inside the PIC.

This project is getting into a smaller scope that will focus on how far and the compatibility of the RFID to scan and detect the card. It is focusing more to analysis of the range between the card and the RFID reader. Then i will make a scaling between the actual parking slot and the prototype that will be make in this project. The total cost of this project is about RM700-800.00 that cause me a lot of money to be needed. This project started from last semester as a proposal first then after this proposal has been approve then it will be proceed to the Project.

I hope this project will be completed because it will affect my pointer result if im fail and also i will be extend to the next semester that will cause me to extend my graduation.

So wish me luck for my final year project.